Author Topic: Introduction and Question to Doug Fir versus Spruce and Epoxy  (Read 1169 times)

Offline Pilotarix

  • Full Member
  • ***
  • Posts: 73
  • Total likes: 84
  • New Member
  • OS:
  • Mac OS X 10.15.7 Mac OS X 10.15.7
  • Browser:
  • Chrome 91.0.4472.114 Chrome 91.0.4472.114
Re: Introduction and Question to Doug Fir versus Spruce and Epoxy
« Reply #15 on: July 08, 2021, 06:24:27 PM »
Thanks!
Yes, miles of glue surface. Birdsmouth spars are pretty tricky to cut especially when they have a taper, which they all have, and gluing them is not much easier. It's a mess, epoxy everywhere.
But enough boat building let's go back to aircraft, in the end, I am going to decide to build another boat ... ::)  :grin:  :))

 

SimplePortal 2.3.7 © 2008-2022, SimplePortal