Eagler's Nest

Airframes => Single Seaters => XL => Topic started by: Kamcoman77 on July 09, 2019, 07:47:49 PM

Title: Lightening Holes In Wing Spar Filler Blocks
Post by: Kamcoman77 on July 09, 2019, 07:47:49 PM

Anybody drill lightening holes in the solid spruce wing fitting filler blocks before putting the plywood webbing over them? Those are some pretty large hunks of wood between the spar caps.

Title: Re: Lightening Holes In Wing Spar Filler Blocks
Post by: Terry Lundby on July 29, 2019, 08:09:59 AM

No, don't remove any material from the filler blocks. These chunks of wood transmit the load from the wing spars to the aluminum fittings that then transmit the load to the fuselage.  Best to follow the plans ;)

Title: Re: Lightening Holes In Wing Spar Filler Blocks
Post by: Kamcoman77 on July 29, 2019, 08:36:26 AM

Thanks. I was just curious. I did not drill the filler blocks except where the fittings bolt through.