Eagler's Nest
Engines => 3 cylinder Radial => Topic started by: Brock on December 28, 2024, 08:43:45 PM
-
I asked Verner what exhaust flange is on the 3VLA and he sent me a generic picture. What I was really hoping for was a p/n so I could find one premade. My engine came with gaskets that I have traced and could make a flange but I was hoping to find a SS premade item. What have others done?
Also, as I'm thinking I'll have to warm up the plazma cutter (which I've not used in 8 years) I'm thinking of the SS cable tabs that go on the tail. Has anyone had a bunch of these laser (water, wire etc) cut?
-
Brock, I made some, then realized there were some in the tool kit, so I have spares I'll send you if you want. Not SS though. I'm out in SoCal right now, so it will be a week or two..
-
I better check the tool kit more closely.
-
I received my 3VLA last week. I do not see any exhaust flanges in the toolbox, just gaskets. Brock, did you locate them in your engine shipment? I may just end up buying some for the Honda twin.
-
I received my 3VLA last week. I do not see any exhaust flanges in the toolbox, just gaskets. Brock, did you locate them in your engine shipment? I may just end up buying some for the Honda twin.
No flanges in my kit. Chuck, though, had ordered a set but then found a set in his box which he was kind to send me.
-
No flanges in my kit. Chuck, though, had ordered a set but then found a set in his box which he was kind to send me.
Actually, I made them on the mill. I probably still have the .dxf file if anyone wants to do the same or take some stock to a water jet shop.
-
Having the dxf file would be great as I have access to a mill and a cnc at work!
Thanks
Pete
-
Having the dxf file would be great as I have access to a mill and a cnc at work!
Thanks
Pete
Sorry, this site won't let me attach a .dxf file. I could email it to you if you PM me your email address.