Here's my version of the Gear-Wing Fittings found on page 12. One thing you'll notice is that my drawing and the plan drawing are not lining up. I imported the picture of the plan and I used the bottom 2-1/2" distance to calibrate the picture. From that it became very obvious that the drawing itself is not to any scale. As a result I took the liberty to make a couple adjustments. I brought the wing strut mounting hole, the longeron, and the inner landing gear mounting hole all into a position so that the center point of these three holes all line up relative to each other. The original plan drawing implies this, by my interpretation, but when the drawing is recreated to scale things just didn't line up as indicated. No matter, here is what I came up with.