Author Topic: Tail surfaces hinges question.  (Read 10808 times)

Offline Shay King

  • Full Member
  • ***
  • Posts: 125
  • Total likes: 152
  • New Member
  • OS:
  • Mac OS X 10.15.7 Mac OS X 10.15.7
  • Browser:
  • Safari 17.14 Safari 17.14
Tail surfaces hinges question.
« on: February 05, 2026, 10:47:11 AM »
I’m trying to figure out what’s the correct way to connect the tail surface hinges to each other.
Is it better to use clevis pins or 3/16 bolts with Castle nuts?
Should I leave space between the hinge pieces for a washer?


Offline Kamcoman77

  • Donor 2026
  • *
  • Posts: 681
  • Total likes: 555
  • Building LE-XL H-51
  • OS:
  • Windows NT 10.0 Windows NT 10.0
  • Browser:
  • Chrome 144.0.0.0 Chrome 144.0.0.0
Re: Tail surfaces hinges question.
« Reply #1 on: February 05, 2026, 12:39:17 PM »
Clevis pins seem a lot simpler, a lot lighter, and take up less space. A nut is a tight fit in some areas. I'm sure either would work, but I'll be using clevis pins & a thin Delrin washer between hinge halves.

Offline Shay King

  • Full Member
  • ***
  • Posts: 125
  • Total likes: 152
  • New Member
  • OS:
  • Mac OS X 10.15.7 Mac OS X 10.15.7
  • Browser:
  • Safari 17.14 Safari 17.14
Re: Tail surfaces hinges question.
« Reply #2 on: February 05, 2026, 01:01:31 PM »
Thanks Keith.