Author Topic: Sq tubing/materials list  (Read 2235 times)

Offline grdev

Sq tubing/materials list
« on: February 18, 2014, 08:44:32 AM »
I was going to weld on m wing mounts today, but I couldn't locate any .062" 1/2" square 4130 tubing in my stock I recently purchased using the XL material list provided with my drawings. looking over my materials list I see it isn't listed. The only 1/2" sq stock I see listed is a one foot piece of .035 & .049.

I started looking at every page of my drawings looking for where square stock was used and this is all I could find:
Pages

7A wing mount .062" x 1/2"
10 control stick ..035? x5/8"
21 rudder stop  .065 x 1//2
Where s the 1' of 7/8" .065, 1' of 1/2" .035, & 1' of 1/2" .049" used?

I've been known to miss the obvious before, any help appreciated.

Offline grdev

Re: Sq tubing/materials list
« Reply #1 on: February 18, 2014, 08:50:06 AM »
I found where the 7/8" was used, I'll:-[  keep searching

Offline Jlwright

  • 2015 Donor
  • *
  • Posts: 192
  • Total likes: 2
  • Building XL-D-25
    • Jim's airplanes
  • Eagle Type: XL-D-25
Re: Sq tubing/materials list
« Reply #2 on: February 18, 2014, 05:57:02 PM »
I am in the same boat I didn't buy any 1/2 by .062 square tube either because it wasn't on the list but it is called out on the drawing for the wing mount. Guess I'll be ordering more material. I need some . 090 flat material anyway.
It's a brutal struggle for the biscuit!
Building XL-D-25 Fuselage 90% done.   ribs done, spars 90% done.

 


SimplePortal 2.3.7 © 2008-2020, SimplePortal